99-03 Powerstroke 7.3 Pusher Intakes Manifold KitFEATURESThe Pusher intake manifold for the 7. 3L Powerstrokes splits the poorly designed one piece factory manifold in two pieces. This drastically reduces the heat transfer between the hot compressed air exiting the turbo to the inlet Y of intercooled air at the cylinder heads. The design has been optimized to deliver equalized flow within . 1% between the left and right outlets. The factory heater coil port is deleted for increased flow as well.

Finally a solution that replaces the problematic factory fuel filter housing that has a plastic cap known to seize and break

100 HP & 200 lb-ft

75”x90° Boot (433-RFAB)

Important tip:

fresh air from the headlight bezel and fender port

BD Diesel was no stranger to the Diesel Truck world

3L Diesel Injector Control Pressure(ICP)

25” – 3” t-bolt clamp

Tested in High HP High Boost applications

We're thrilled to announce the Juice/Attitude for the 2018 RAM 6

If your diesel is on the down-low

Smarty does NOT set ANY codes once the ECM is set back to stock