Heat-treated steel tapping screws. Mechanical properties1 Scope This International Standard specifies the characteristics of heat treated steel tapping screws, with tapping screw thread from ST2,2 to ST9,5 inclusive according to ISO 1478, together with the corresponding test methods.

While the recommendations given in this part of BS EN ISO 9241 apply to a wide range of available front-end technologies

Why should you use BS EN IEC 55016-1-1 - Radio disturbance and immunity measuring apparatus about

BS EN ISO 11138-2:2006 provides specific requirements for test organisms

The types of coupling to be considered for operating and fault conditions of the high voltage a

BS EN 61754-23 on fibre optic connector interfaces for the type LX

Change of title to reflect the wider scope of this revision

While primarily intended to be used with VHF/UHF DVB-T and DVB-T2 receivers and signal distribution systems

BS EN 12698-2 on XRD methods for chemical analysis of nitride bonded silicon carbide refractories is useful for:

and guidelines

Why should you use BS 7383- Specification for Resin-based compound used in terminating cables

which affects splice loss

BS EN 62011-1 covers both rods and tubes of natural colour and those containing colouring matter or other additives